VERICUT Users' Forum

DNGUYEN1

Member

From: KS

Registered: 2005-06-16

Posts: 32

Machine crash

Hello All,
I have a job was crash on horizontal machine (88E Makino)  due to the Z axis was not retract far enough
so the tool  hit to the Tombstone during 'B' axis rotation, So I have to show my Boss  the Vericut with Machine Simulation and everything  was  clear ,
and no tool crash with the Vericut
I was wondering why Machine Sim did not catched? 
Any help would be appreciated.

    Dnguyen

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Machine crash

Try
Control settings+
Rotary tab
Output intermediate points = YES

Dave

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

DNGUYEN1

Member

From: KS

Registered: 2005-06-16

Posts: 32

Re: Machine crash

Thank you Dave!!