VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2010-06-26 23:52:54

chrisclub
Member
Registered: 2010-05-14
Posts: 2

A-Axis move doesn't rotate stock

Haasminimill.ctl/mch,
I am doing a G1 X2.0 A90., The tool cuts a groove in the X direction, but the stock does not rotate, so no helix is formed.


OK, found the answer... must use machine: "generic_4ax_vmill_table_a.mch".

Offline

Pages: 1

Board footer