VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2010-06-08 14:34:25
- MIKEFITZ
- Member
- From: Chicopee, MA
- Registered: 2009-06-18
- Posts: 104
Shifting Pickups
Hey everyone. I am simulating a job on an Okuma MX-40 HA. I am using the osp7000m.ctl from v6.1.2, although I am running v7.0.3 now. the control itself seems to be working fine, except everytime I open a job on this particular machine, the pickups shift by .500. I don't know what is going on, whether it's the machine, the control, or something else, but it is very frustrating to have to reset the pickups everytime I open the job, not to mention time consuming.
So far, this seems to be the only machine that this happens on...all the others stay right where they are.
Any ideas what could be causing this? 
TIA
mike
Mike
Hoppe Tool
Offline
Pages: 1