You are not logged in.
Pages: 1
I've got a problem with a circle motion G03. The subprogram for cirlces is programed in G91 incremental mode. This subprogram is used more than one times, in the first one, the circle is made correctly but in a second one the entry of the tool is wrong programed. Are there any options to configure this entries to avoid this problem?? I've seen one option for entries in optipath but I'm not interested using them.
Thanks
Offline
>Setup >Control >Settings >Circles
Austin NC APT administrator.
Custom configure GPost for Pro/E,
and other ANC applications.
Offline
Pages: 1