VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2009-06-19 11:37:08

MIKEFITZ
Member
From: Chicopee, MA
Registered: 2009-06-18
Posts: 104

Taps

As far as I know, there is no way to make taps in 6.1.2 other than to make an endmill with the same measurements. This works okay, but it would be nice to be able to see the threads, which would help in the Auto-Diff to be able to more easily distinguish between threaded holes and non-threaded holes/c'bores.

Mike
Hoppe Tool

Offline

#2 2009-06-22 13:03:25

Svante
Senior Member
From: Trollhättan, Sweden
Registered: 2005-02-23
Posts: 60

Re: Taps

Hi Mikefitz,

From 6.2.1 it's possible to define tapping tools. Even though I have had some headache to make the feedrate work on them.

Svante Eriksson
System owner
GKN Aerospace Engine Systems Sweden
Vericut 7.2.1, 7.3.4, 7.4 - NX 9.0.3

Offline

Pages: 1

Board footer