VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2009-03-09 11:05:39
- DGK2208
- Member
- Registered: 2009-03-09
- Posts: 2
Peck Tapping cycle
I am trying to set a tap cycle for am Okuma Control & get message below
not sure why ? 
Warning for line 9300
G282 X.5 Y-.565 Z-.308 R-.02 S200 Q.05 F5. M54
Q 0.05 is not supported
Offline
#2 2009-05-06 07:52:48
- Dolf
- Member
- From: EDE, The Netherlands
- Registered: 2005-01-09
- Posts: 15
Re: Peck Tapping cycle
This means that the Q Word does not have the correct macro attached.
Add the correct VERICUT macro the the Q Word in the Control. See (Okuma) showroom files.
Offline
Pages: 1