VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-02-10 04:54:34
- DavidB
- Member
- From: Australia
- Registered: 2005-02-09
- Posts: 27
Mastercam - Vericut
Anyone using the Vericut c-hook in Mastercam?
Does it bring in Tool build up from Masteercam?
Thanks
Offline
#2 2005-02-15 17:21:53
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Mastercam - Vericut
Hello David,
The C-Hook automatically transfers all the setup information including tools, tool paths, and stock location to VERICUT in their proper orientation.
Best regards,
Serge
Offline
Pages: 1