VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to:

You are not logged in.

#1 2008-07-11 20:28:03

VERICUT Specialist
From: Irvine, CA
Registered: 2004-10-08
Posts: 146

VERICUT 6.2 and CAD Model Interfaces on XP64 fails

The CAD Model Interface installation originally available with VERICUT 6.2 did not work on XP64. An updated installer for the CAD model interfaces is now available via the link in the on-line install documentation. The on-line installation documentation has been updated.

The VERICUT After-Installation Configuration Instructions references the new install document.

Note: This version of CAD model interfaces supports CATIA V5 R18.


Board footer