VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to:

You are not logged in.

#1 2021-03-04 22:50:54

Registered: 2021-01-16
Posts: 8

Back Boring Tool?

Is there a way to use vericut with a back boring tool? If I model the tool with the size that it is supposed to cut it will put that hole all the way thru the part. Is there a way to model tools and only have the tool revolution active when the spindle is turning? With the back boring tool you go thru the hole with the spindle not move, move to the center of the hole and then turn the spindle on and feed.


#2 2021-03-05 16:55:26

From: Crewe, England
Registered: 2007-02-20
Posts: 159

Re: Back Boring Tool?

There is a sample (back_bore ... ) that shows various ways to back bore in Vericut.  You should have it in a standard install.

Let me know if you need any further help.



Board footer